The automatic transmission is a complex assortment of components whose primary function is to transfer raw engine horsepower into usable torque to move the vehicle forward or backward. To handle this task the transmission has a series of clutches and gears that are controlled by hydraulic pressure. Whenever the vehicle needs to shift the gears, a pressure change inside the transmission adds or removes them as required. Unfortunately, this constant shifting can cause problems, especially in an already dirty transmission. For instance, if the gears slip while shifting it can cause part of the fiber on the internal clutches to wear off.
Most common transmission damage can be avoided with regular maintenance and a simple Transmission Repair in Conroe. That is, the transmission needs to have the fluid replaced and the system thoroughly flushed. This process washes out all the tiny channels that the transmission uses to route the fluid where it is required. Removing sludge from the system restores power and reduces the possibility of future damage.
Of course, not all transmission damage is that simple. Once the transmission has acquired a lot of miles, the internal parts will have worn down quite a bit. At this point, there are two options. The first is to rebuild the existing transmission and the second is to replace the unit with a rebuilt model. The end result is basically the same, but most mechanics suggest the latter repair because the replacement transmission is factory rebuilt and comes with a better warranty. You should contact Discount Brake & Auto Repair for further details.
Other types of Transmission Repair in Conroe are the ones done for the standard shift transmission. This is a very rugged device, so the internal damage is fairly rare, but problems can occur in the clutch system or with the shift linkage. The clutch is the device used to disengage the transmission from the engine so that the driver can shift gears. The more the clutch is used, the more it wears down. Eventually, a mechanic will need to replace the device and any parts required for its function such as the pressure plate or throwout bearing.
